Pacific Flow Indicator One
Pacific Flow Indicator One
SKU:CL-W106-PL00BL-A
Couldn't load pickup availability
G1/4 thread flow indicator makes it easy to visually check your flow of the system.
-
Design
-
Specification
-
Download
-
How-to Videos
Thermaltake Pacific Flow Indicator One
By installing a safety valve into the cooling loop, the new Pacific Flow Indicator One with
five fan blades design provides a great way to check the flow of the system. Featuring
exceptional performance and unrivalled reliability, the Pacific Flow Indicator One is
compatible with any standard G1/4 fitting on each end and is manufactured from high quality
POM and PMMA material to provide a crystal clear, high performance, and durable liquid
cooling solution.
Tt LCS Certified
Tt LCS Certified is a Thermaltake exclusive certification
applied only to products that pass the design and hardcore enthusiasts standards that a true
LCS chassis should hold to. The Tt LCS certification was created so that we at Thermaltake
can indicate to all power users which chassis have been tested to be best compatible with
extreme liquid cooling configurations, ensuring you get the best performance from the best
features and fitment.
True High-Flow Design
Made in Taiwan, both ends of the Pacific Flow Indicator One
are G1/4 thread with five fan blades design; users can use any standard fitting on each end.
The high quality PMMA cover allows users to directly see through the flow indicator.
Changeable Flow Direction
Users can freely change the flow direction of the Pacific
Flow Indicator One either clockwise or counterclockwise. Plug and play design – no
additional tools needed and ready to work in seconds.
Easy & Flexible Application
Pacific Flow Indicator One allows enthusiasts to build a
superior water cooling system from an aesthetic standpoint and incorporate
externally-modular upgrades into their chassis.
Cautions
Thermaltake recommends the following steps to be taken
after completing your water loop setup
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.
