Skip to product information
Pacific SF Hard Tube 16mm OD Compression - Matte Black
Pacific SF Hard Tube 16mm OD Compression - Matte Black
Pacific SF Hard Tube 16mm OD Compression - Matte Black
Pacific SF Hard Tube 16mm OD Compression - Matte Black
1 of 4

Pacific SF Hard Tube 16mm OD Compression - Matte Black

Pacific SF Hard Tube 16mm OD Compression - Matte Black

SKU:CL-W389-CA16MK-A

Regular price $12.99 USD
Regular price Sale price $12.99 USD
Sale Sold out

View full details

New Industrial Style with a Better Grip

The Pacific SF Fittings are forged with Industrial Style Helical Knurling Designed Rotators made with high-quality brass and treated with a special surface finishing, creating a new look with fantastic aesthetics and providing a more ergonomic grip while installing.

Install Freely without Worry

Pacific SF Hard Tube 16mm OD Compression fittings can be used with PETG, Acrylic, and Glass tubing, which is 16mm in outer diameter (OD) and paired with G1/4 screw threads. They are designed to work in tight spaces without compromising the compression seal or impacting the coolant flow. They also feature four O-Rings to provide a more secure seal and reliable performance.

Thermaltake Pacific SF Fittings Installation Guide

Step 1. Slide the compression nut over the tube
Step 2. Install the O-Ring
Step 3. Install the packing
Step 4. Install the fitting base on your components
Step 5. Tighten the compression nut

Caution: The O-Ring and the packing with a groove on the inside diameter must always be installed towards the top of the compression nut.

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.